Hi!
Probably you didn't specify the correct port your scanner is connected
to. You can do this in the file mustek_pp.conf:
port <your port>
You can try all three possible values: 0x378 0x278 0x3BC, or you know
the value, or you have a look a /proc/ioports (after printing something,
so parport is loaded)...
If it doesn't work, please send the output of
# SANE_DEBUG_SANEI_PA4S2=128 scanimage -L
and
# cat /proc/ioports
(after printing something)
-- jochen
[fabrice.fontaine.552@B-RAIL.BE]
>
> Hi ,
>
> I have downloaded sane 1.0.3 (that includes the SANE interface sanei_pa4s2
> and the backend sane-mustek_pp) and xsane 0.60 .
>
> I have done in the sane 103 directory : ./configure
> make
> make install
>
> everything is OK , sane is compiled and installed.
>
> When i look in the makein , dll.conf .... files the options for sanei_pa4s2
> and mustek_p are ok
> (i have deleted the # before mustek_pp and replaced lp1 by lp0 )
>
> but my scanner (lifetec (aldi) LT9891on parallel port isn't dedected).
>
> When i type scanimage -L , it shows nothing.
> When i type scanimage , it shows no device found.
>
> Xsane refuses to be compile , make gives an error 1 "file sane preference.h
> not found".
>
> What should i do now ?
>
> Is there something to configure, a module .so to load ?
> I am a beginner with Linux ?
>
> I have read some doc but i don't find what to do , there is a find-scanner
> tool but it seems to be for the scusi scanners...
>
> Thank you.
>
> Fabrice Fontaine
>
> Belgium
>
>
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
This archive was generated by hypermail 2b29 : Thu Aug 24 2000 - 01:54:06 PDT