Re: Xsane & no devices

From: Bill Thompson (billt@samart.co.th)
Date: Sat May 27 2000 - 22:16:23 PDT

Next message: Oliver Neukum: "Announcing new driver"

Previous message: Douglas Gilbert: "Re: SOLVED: 2 scanners scanning at the same time?"
In reply to: Steve Sheriff: "Re: Xsane & no devices"
Next in thread: Alvaro Nunes: "Re: Xsane & no devices"
Next in thread: Timothy Reaves: "Re: Xsane & no devices"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Steve Sheriff wrote:
>
> On Sat, 27 May 2000, you wrote:
> > Hello,
> >
> > I guess this question is asked before, but i cannot figure out how to do this.
> >
> > I had Sane-1.0.1 installed, and I want to use 1.0.2.
> > Now I want to use Xsane 0.59, but all it gives to me is "no devices available"
> >
> > And I really removed all of sane-1.0.1, ran ldconfig and rebooted.
> > I can't figure out how to do this.
> > Sane works, so that's no problem.
> > I'm using a Microtek(2) parport.
> >
> > Thanks in advance
> >
>
> My /dev/sga0 permissions were wrong after installation of 0.59 and 1.0.2.
>
> Hope this helps. Steve.
>
> --
> Source code, list archive, and docs: http://www.mostang.com/sane/
> To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com

It helped me. And it came at a time I really needed my scanner.

Mucho, thanks,

Bill

-- From the shores of Khlong YaiPhuan, Bangkok, Thailand...

-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com

Next message: Oliver Neukum: "Announcing new driver"
Previous message: Douglas Gilbert: "Re: SOLVED: 2 scanners scanning at the same time?"
In reply to: Steve Sheriff: "Re: Xsane & no devices"
Next in thread: Alvaro Nunes: "Re: Xsane & no devices"
Next in thread: Timothy Reaves: "Re: Xsane & no devices"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Sat May 27 2000 - 22:14:40 PDT