beyond the setting SANE_DEBUG_MUSTEK=128, none. According to the output,
[sanei_init_debug]: Setting debug level of mustek to 128.
[mustek] sane_init: strip-height set to 1 inches
[mustek] attach: opening /dev/scanner as scsi device
[mustek] attach: sending INQUIRY
[mustek] scsi_wait_ready: sending TEST_UNIT_READY
[mustek] attach: firmware revision 2.02
[mustek] attach: found Mustek scanner model C06 S12IDW (flatbed scanner),
1-pass, SE
scanimage: sane_start: Invalid argument
the device is identified correctly, but cannot be started.
This didn't change after eliminating the *-fix lines from
/usr/local/etc/sane.d/mustek.conf:
*************************************************mustek.conf:******************
# See sane-mustek(5) for documentation.
option strip-height 1
#scsi SCANNER
/dev/scanner
*******************************************************************************
> BTW: Your mustek.conf should not contain anything except for
> the device specification. No *-fix at all. Those
> are intended exclusively for some older scanners.
>
>
> --
> Source code, list archive, and docs: http://www.mostang.com/sane/
> To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
>
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com