highscreen highscan

From: Sönke Ruempler (ruempler@topconcepts.com)
Date: Tue Jul 03 2001 - 09:27:57 PDT

  • Next message: Oliver Neukum: "yet another release"

    Hi,

    I have a scanner called Highscan MRS-600E3. its attached to a adaptec
    ava1502 scsi controller.

    the controller works fine with the aha152x module and the scanner is
    recognized as sg0.

    here is a scanimage -L:
    device `microtek:/dev/scanner' is a Microtek ScanMaker E3 flatbed
    scanner

    but if i do a scanimage -T, the folloing appears:
    scanimage: sane_start: Device busy

    /var/log/messages says:
    Jul 3 18:27:02 blah kernel: (scsi0:6:0) cannot abort running or
    disconnected co
    mmand
    Jul 3 18:27:02 blah kernel: (scsi0:6:0) cannot reset current device
    Jul 3 18:27:02 blah kernel: aha152x0: scsi reset in
    Jul 3 18:27:08 blah kernel: scsi: device set offline - not ready or
    command ret
    ry failed after bus reset: host 0 channel 0 id 6 lun 0

    The ready lamp at the scanner is off.

    I hope someone can help me :|

    -- 
    

    Mit freundlichem Gruß Sönke Ruempler

    top concepts Internetmarketing GmbH ------------------------------------------------------ http://www.topconcepts.com Tel. +49 4141 9912 30 mail: ruempler@topconcepts.com Fax. +49 4141 9912 33 ------------------------------------------------------ 24h-Support Hotline: +49 1908 34697 (€ 1.86/Min,CNS24) ------------------------------------------------------

    -- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com



    This archive was generated by hypermail 2b29 : Tue Jul 03 2001 - 09:21:40 PDT