Might try a kernel upgrade, 2.3.19 is a wee bit behind the current
release. I'm running the same scanner on a dual P II 300 BX chipset
under kernel version 2.3.99-pre3 with no problems. That's using the
SCSI interface to the scanner.
On Wed, 29 Mar 2000,
Kurt Savegnago wrote:
> I just installed sane-1.0.2 in a PR440FX dual Pentium Pro machine
> with an SMP 2.3.19 kernel. Sane and xsane built and installed O.K.
> for an H-P 6300C scanner but the computer just locks up when I try to
> run it. Does this have anything to do with SMP and or lack of support?
> The Winblows side works with the scanner but the Winblows software
> I have leaves little to desire as far as manipulating images. I prefer
> to begin using the GIMP.
> Also is there a new server I can go to peruse these messages or
> do I still need to go to mostang.com. I am subscribed already so
> the messages are automatically sent to me.
> Best regards,
> Kurt Savegnago
> Source code, list archive, and docs: http://www.mostang.com/sane/
> To unsubscribe: echo unsubscribe sane-devel | mail email@example.com
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail firstname.lastname@example.org
This archive was generated by hypermail 2b29 : Wed Mar 29 2000 - 08:11:54 PST