> Hugo van der Kooij wrote:
> > > Attached devices:
> > > Host: scsi0 Channel: 00 Id: 06 Lun: 00
> > > Vendor: N-TEK Model: NuScan II Rev: 1.60
> > > Type: Scanner ANSI SCSI revision: 03
> > Do you have Generic SCSI support at all? It's propably missing in the
> > kernel or it's a module you didn't load.
>
> Yes. I'm running vanilla Red Hat 6.0. 'cat modules' shows
> sg 3824 0 (autoclean) (unused)
>
> Just to make sure, I recompiled a kernel without modules,
> and with generic scsi installed. No change.
> I also set permissions on /dev/sg0 (= /dev/sga) to
> 664. No joy. But setting permissions to 666 did something
> very different; guess installing
> sane-1.0.1-2.i386.rpm and sane-clients-1.0.1-2.i386.rpm
> doesn't create executables that are setgid to scanner
> (makes sense, since the scanner group didn't exist after the install).
That's right. Because the number of possible options one could run into I
didn't set suid or sgid the binaries in the package.
Hugo.
--
Hugo van der Kooij; Oranje Nassaustraat 16; 3155 VJ Maasland
hvdkooij@caiw.nl http://home.kabelfoon.nl/~hvdkooij/
--------------------------------------------------------------
Use of any of my email addresses for unsollicited (commercial)
email is a clear intrusion of my privacy and illegal!
--
Source code, list archive, and docs: http://www.mostang.com/sane/
To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com